|
[Sponsors] |
August 15, 2013, 08:04 |
Error no control surface
|
#1 |
New Member
Drillerman
Join Date: Aug 2013
Location: Germany
Posts: 4
Rep Power: 12 |
Hello:
I am new in CFX, I try to study the Pressure wave propagation inside water pipes. I make now run for unsteady state, and become this Error: no control surface have been found at all for PulserPositivepulser G1. To work around this please se expert parameter ggi permit no intersection=t Could any one help me, how can I make this!!! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
Calculation of the Governing Equations | Mihail | CFX | 7 | September 7, 2014 06:27 |
[ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
Invert control surface Ap?? | sercro | CFX | 0 | March 16, 2011 12:53 |
Recover surface from surface mesh in IcemCFD | Jerry Tanner | CFX | 0 | August 20, 2008 12:48 |