 |
 |
 |
|
|
|
[Sponsors] | ||||
July 19, 2013, 13:36
|
INSUFFICIENT MEMORY ALLOCATED Error
|
#1 |
|
New Member
Rameez
Join Date: May 2013
Posts: 19
Rep Power: 12  |
Can someone please explain this error?
I had earlier given a run which happened succesfully, now i tried increasing the mesh size and i'm getting this error. What does it signify? Is it something to do with CPU RAM? *** INSUFFICIENT MEMORY ALLOCATED *** | | | | ACTION REQUIRED : Increase the real stack memory size. | | | | Details : | | Requested space : 7635312 words | | Current allocated space : 67487312 words | | Current used space : 56877305 words | | Current free space : 10610007 words | | Number of free areas : 14 | +--------------------------------------------------------------------+ Details of error:- ---------------- Error detected by routine MAKDAT CDANAM = ACS CDTYPE = REAL ISIZE = 7635312 CRESLT = FULL Current Directory : /FLOW/ASSEMBLE/TIME-0/ZIF8/HYDRO_CM1 +--------------------------------------------------------------------+ | Writing crash recovery file | +--------------------------------------------------------------------+ ERROR #001100279 has occurred in subroutine ErrAction. | Message: | Stopped in routine MEMERR |
|
|
|
|
|
July 19, 2013, 13:55
|
|
#2 |
|
New Member
Rameez
Join Date: May 2013
Posts: 19
Rep Power: 12 |
Thanks i got the solution to it, i should increase memory allocation factor
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Compile calcMassFlowC | aurore | OpenFOAM Programming & Development | 13 | March 23, 2018 07:43 |
| Compile problem | ivanyao | OpenFOAM Running, Solving & CFD | 1 | October 12, 2012 09:31 |
| Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |
| Compiling problems with hello worldC | fw407 | OpenFOAM Installation | 21 | January 6, 2008 17:38 |
| user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |
Linear Mode
