 |
 |
 |
|
|
|
[Sponsors] | ||||
August 27, 2013, 06:19
|
Moving mesh and boundary layer
|
#1 |
|
New Member
Join Date: May 2011
Posts: 22
Rep Power: 14  |
Hi every
Is it possible have the mesh motion analysis and consider hex or prism mesh for boundary layer? For example in: http://www.edr.no/blogg/ansys_blogge...cfx_re_meshing use the hex or prism mesh around the body in order that increase mesh quality. Cheers |
|
|
|
|
|
August 27, 2013, 06:28
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
Yes, you can use hex or prisim meshes with moving mesh.
|
|
|
|
|
|
|
August 27, 2013, 06:36
|
|
#3 |
|
New Member
Join Date: May 2011
Posts: 22
Rep Power: 14 |
Don't remesh when I use prism mesh. Do I have to define a subdomain in ICEM for that?
Last edited by Spring.s; August 27, 2013 at 23:45. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
| Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
| RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Linear Mode
