|
[Sponsors] |
September 29, 2013, 09:54 |
Help me
|
#1 |
New Member
Arief
Join Date: Sep 2013
Location: Surabaya
Posts: 12
Rep Power: 12 |
Hello Guys,
I have some problem with modelling ansys cfx 13. I make a pipe 3d (with material water) and i put a small cube (Solid) inside that pipeline. I have followed the instruction step by step, starting from geometry, mesh, set-up, solution, until result. My problem is on stage at the result or when running commands streamlined, fluid flow was not flowing through the current splitting cube which resides in the pipeline but the stream directly penetrate the cube. So anyone know what, if there is a step or menu commands that may be run first ? Or perhaps on the order set-up there is a command that must be done first ! If anyone ever encountered and who understand how settlement instructions please.. Thank you... |
|
September 30, 2013, 10:40 |
|
#2 |
Senior Member
OJ
Join Date: Apr 2012
Location: United Kindom
Posts: 473
Rep Power: 19 |
Can you post some images?
|
|
Tags |
penetrate the cube |
Thread Tools | Search this Thread |
Display Modes | |
|
|