|
[Sponsors] |
September 29, 2013, 23:21 |
solving time duration
|
#1 |
New Member
sina
Join Date: Jul 2013
Posts: 5
Rep Power: 12 |
Hi friends.
I'm working on blood flow simulation with FSI condition. Actually right now i have doubt about my result because my solving time duration is to short, for example about 20 minutes. Many times ago i had such this simulation and its solving time duration was approximately 3 hours with i7 CPU. I should say right now i'm working with Ansys12 and i'm using CFX mesh but before i used Ansys13 and Ansys meshing. please tell me what's wrong with this. |
|
September 30, 2013, 03:50 |
|
#2 |
Senior Member
Lance
Join Date: Mar 2009
Posts: 669
Rep Power: 22 |
well, why dont you look at the results/output files to see that you are getting all the results you want? 20 minutes for a FSI sounds like a short time, maybe you are only solving the fluid part?
|
|
October 2, 2013, 17:38 |
|
#3 |
New Member
sina
Join Date: Jul 2013
Posts: 5
Rep Power: 12 |
Actually i took results for fluid and solid . for example i found out Von Misses stress for solid part and also different contour for pressure and velocity and it was acceptable bud for example i can not catch good streamline for velocity.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Extrusion with OpenFoam problem No. Iterations 0 | Lord Kelvin | OpenFOAM Running, Solving & CFD | 8 | March 28, 2016 12:08 |
pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 09:35 |
calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 07:37 |
pisoFoam - unstable pressure residual | Industrial_CFD | OpenFOAM Running, Solving & CFD | 21 | February 24, 2013 16:39 |
pisoFoam with k-epsilon turb blows up - Some questions | Heroic | OpenFOAM Running, Solving & CFD | 26 | December 17, 2012 04:34 |