 |
 |
 |
|
|
|
[Sponsors] | ||||
October 27, 2013, 23:24
|
centrifugal compressor
|
#1 |
|
Member
aysiyi
Join Date: Nov 2012
Posts: 40
Rep Power: 13  |
Hello,
I'm new to CFX software. I am trying to stimulate a centrifugal compressor. the model include a impeller passage, a diffuser passage,a whole volute. The inlet boundry is total pressure, total temperature, direction of velocity. The outlet boundry is mass flow. it is a steady stimulation. But after 800 iterations, the inlet appears 100% reflow(回流)，and it con't convergenced, who can help me? thanks! |
|
|
|
|
|
October 28, 2013, 04:09
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,692
Rep Power: 143 |
Inlet or outlet the answer is the same: http://www.cfd-online.com/Wiki/Ansys...f_an_OUTLET.22
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Possible to simulate a working Centrifugal Compressor for jet engine on OpenFOAM? | fazlur | OpenFOAM | 1 | August 21, 2013 04:30 |
| Centrifugal compressor mass flow error | Attesz | CFX | 18 | May 27, 2012 10:17 |
| how to solve the diverage of high speed centrifugal compressor, CFD code is STAR CCM | layth | STAR-CCM+ | 3 | May 21, 2012 05:48 |
| [ICEM] Meshing a centrifugal compressor impeller | Mitpostdoc | ANSYS Meshing & Geometry | 8 | February 25, 2011 10:51 |
| centrifugal compressor | siva appanna | Main CFD Forum | 5 | February 13, 2006 21:07 |
Linear Mode
