Immersed Solid Momentum Sources inside function

Martinw · October 10, 2013, 06:07

Hi,

Im trying to understand the Immersed Solid Method in Ansys CFX 14.5

In the Theory Guide under 1.4.1. Momentum Sources they mention the "volume-averaged inside function". What does this function do? Can someone help me to understand it?

They write in the Theory Guide:

"The presence of an immersed solid in the flow field is modeled through a special forcing function. If no near-wall treatment is used near the immersed solid boundary, the function is set to be zero for fluid nodes lying outside the immersed solid domain, and one for fluid nodes inside the immersed solid. If near-wall treatment is activated, the function is set to be volume-averaged inside function so that the values and the corresponding forcing terms near the immersed boundary will be non-zero. The volume-averaged inside function averages the inside function, weighted by the nodal volume."

ghorrocks · October 10, 2013, 17:14

If the whole control volume is within the immersed solid, then the momentum source (MS) is fully applied. If it is wholly outside the immersed solid the MS is not applied. But what about the control volumes which are partially inside and partially outside the solid? It is just saying it works out the proportion of the control volume which is inside the solid, and weights the MS with the proportion.

October 10, 2013, 06:07	Immersed Solid Momentum Sources inside function	#1
Martinw New Member Join Date: Oct 2013 Posts: 5 Rep Power: 12	Hi, Im trying to understand the Immersed Solid Method in Ansys CFX 14.5 In the Theory Guide under 1.4.1. Momentum Sources they mention the "volume-averaged inside function". What does this function do? Can someone help me to understand it? They write in the Theory Guide: "The presence of an immersed solid in the flow field is modeled through a special forcing function. If no near-wall treatment is used near the immersed solid boundary, the function is set to be zero for fluid nodes lying outside the immersed solid domain, and one for fluid nodes inside the immersed solid. If near-wall treatment is activated, the function is set to be volume-averaged inside function so that the values and the corresponding forcing terms near the immersed boundary will be non-zero. The volume-averaged inside function averages the inside function, weighted by the nodal volume."

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
whats the cause of error?	immortality	OpenFOAM Running, Solving & CFD	13	March 24, 2021 07:15
[ANSYS Meshing] Solid inside Fluid - Multizone meshing	supercolli	ANSYS Meshing & Geometry	2	July 9, 2014 13:20
Problem with compile the setParabolicInlet	ivanyao	OpenFOAM Running, Solving & CFD	6	September 5, 2008 20:50
Droplet Evaporation	Christian	Main CFD Forum	2	February 27, 2007 06:27
meshing F1 front wing	Steve	FLUENT	0	April 17, 2003 12:37

October 10, 2013, 17:14		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	If the whole control volume is within the immersed solid, then the momentum source (MS) is fully applied. If it is wholly outside the immersed solid the MS is not applied. But what about the control volumes which are partially inside and partially outside the solid? It is just saying it works out the proportion of the control volume which is inside the solid, and weights the MS with the proportion.