ERROR: Invalid pitch angle on domain interface

cbaraj · October 23, 2013, 05:21

I cant run my simulation there is an error showing "CFx Solver does not produce a result ". when i check the output file it says "Invalid pitch angle was found on side 2 of domain interface.
How can i solve it ??

ghorrocks · October 23, 2013, 07:11

By fixing up the pitch angle. Looks pretty obvious to me.

cbaraj · October 24, 2013, 07:01

I had given the value to be 1. I am doing transient analysis of single nozzle pelton turbine. i tried to change value to angle and gave 40 and 45. it then said divide by zero error.
what is the physical significance of the pitch angle?

October 23, 2013, 05:21	ERROR: Invalid pitch angle on domain interface	#1
cbaraj New Member Join Date: Sep 2013 Posts: 8 Rep Power: 12	I cant run my simulation there is an error showing "CFx Solver does not produce a result ". when i check the output file it says "Invalid pitch angle was found on side 2 of domain interface. How can i solve it ??

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] interface problems_2D mesh with a rotational domain inside a static domain TO FLUENT	HHOS	ANSYS Meshing & Geometry	1	September 26, 2013 13:25
Error finding variable "THERMX"	sunilpatil	CFX	8	April 26, 2013 07:00
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55
Fluid-2 domain interface	harry	CFX	0	November 6, 2004 06:01
Replace periodic by inlet-outlet pair	lego	CFX	3	November 5, 2002 20:09

October 23, 2013, 07:11		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,700 Rep Power: 143	By fixing up the pitch angle. Looks pretty obvious to me.

October 24, 2013, 07:01		#3
cbaraj New Member Join Date: Sep 2013 Posts: 8 Rep Power: 12	I had given the value to be 1. I am doing transient analysis of single nozzle pelton turbine. i tried to change value to angle and gave 40 and 45. it then said divide by zero error. what is the physical significance of the pitch angle?