|
[Sponsors] |
November 27, 2013, 05:56 |
Transfer ccl from cfx file in command line
|
#1 |
New Member
Jarda Chlup
Join Date: Aug 2013
Posts: 21
Rep Power: 12 |
Hi everybody,
I'd like obtain ccl from cfx without using CFX-Pre. Does anybody have experience with that? I think that it could be possible to use command line in CFX launcher for that, but I don't know command for that. Thanks for help |
|
November 27, 2013, 06:37 |
|
#2 |
Senior Member
Lance
Join Date: Mar 2009
Posts: 669
Rep Power: 22 |
You should be able to extract ccl using cfx5cmds, have you tried that?
|
|
November 29, 2013, 04:44 |
|
#3 |
New Member
Jarda Chlup
Join Date: Aug 2013
Posts: 21
Rep Power: 12 |
Thanks a lot, I found it in old posts. I was thinking about this option, but it looked very simple and fortunately it works
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] OpenFOAM Installation for navalFoam | sachinlb | OpenFOAM Community Contributions | 22 | July 28, 2017 05:26 |
[swak4Foam] groovyBC in openFOAM-2.0 for parabolic velocity bc | ofslcm | OpenFOAM Community Contributions | 25 | March 6, 2017 10:03 |
2.0.x on Mac OSX | niklas | OpenFOAM Installation | 74 | March 28, 2012 16:46 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |