 |
 |
 |
|
|
|
[Sponsors] | ||||
November 28, 2013, 04:16
|
Heater problem
|
#1 |
|
New Member
Join Date: Nov 2013
Posts: 1
Rep Power: 0  |
Hello People, I am new to ansys simulations i need help. I am trying to simulate a rectangular hollow box (made of aluminium)with a heater inside (heat gen rate 1w) fluid (air/water) flows from the box. i need to find out how the temperature in the box. Geometry attached.
|
|
|
|
|
|
November 28, 2013, 16:22
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
There is no attachment.
The place to start learning CFX is the tutorials. Have you done these? Also there are additional tutorials on the ANSYS community website. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
| Problem in implementing cht | tilek | CFX | 3 | May 8, 2011 08:39 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
| Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |
Linear Mode
