|
[Sponsors] |
Particle Transport Modeling_filter on the interface |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 30, 2017, 04:30 |
Particle Transport Modeling_filter on the interface
|
#1 |
New Member
Join Date: Nov 2014
Posts: 18
Rep Power: 11 |
Hi
I'm doing a Particle Transport Modeling in Ansys CFX. I have two regions that are connected as shown in the picture. One region is the main domain and has an inlet flow of air and particles. The second sub-domain acts like a vacuum pump. In the real physical model, there is a filter on the interface of these two regions that does not allow particles to enter the second region. Now, my question is how can I limit the flow such that no particles enter the second region in the Ansys CFX? I should also mention that I do not want to use porous media models. |
|
March 31, 2017, 12:18 |
|
#2 |
New Member
Join Date: Nov 2014
Posts: 18
Rep Power: 11 |
any advice please?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
My radial inflow turbine | Abo Anas | CFX | 27 | May 11, 2018 01:44 |
Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Particle transport model! | Danney | CFX | 2 | April 15, 2003 02:24 |