|March 7, 2014, 01:02||
Join Date: Mar 2014
Posts: 2Rep Power: 0
I appreciate your advice.
I will ask you again.
I try to analysis of flow characteristics in vertical pipe for urban drainage using CFX.
And I will compare the difference between single phase analysis and two phase analysis to verify the effects of the air.
But, I don't know how set up CFX for single phase.
I know that CFX set up multi-phase basically.
|March 7, 2014, 05:06||
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 12,831Rep Power: 100
Have you done the tutorials? Your single phase simulation sounds like very basic stuff and that is well covered by the first few tutorials.
You can find the tutorials in the Help menu, under tutorials.
|March 7, 2014, 10:49||
Join Date: Jun 2012
Posts: 312Rep Power: 7
Do ALL of the tutorials. Even if they're not applicable to your problem, do ALL of the tutorials.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Pump Cavitation Analysis in ANSYS CFX||techCAE||CFX||6||July 3, 2013 06:37|
|CFX Analysis of a wind turbine||Bournegenius||CFX||16||August 20, 2012 19:16|
|Convergence of CFX field in FSI analysis||nasdak||CFX||2||June 29, 2009 01:17|
|RTD is single phase system in Kenics Mixer||vaibhav IIT Delhi||FLUENT||0||October 17, 2002 14:05|
|How to Model Three Phase Clay Slurry in CFX 5.5||J.Yang||CFX||2||August 28, 2002 12:06|