|
[Sponsors] |
April 10, 2014, 06:52 |
Turbocharger turbine
|
#1 |
New Member
Naveen B
Join Date: Feb 2014
Location: Bangalore, Shimoga
Posts: 3
Rep Power: 12 |
I am doing CFD analysis of turbocharger turbine so i am doing analysis in CFX here i have given run for 2.5 lac, 3 lac, 3.5 lac, 4 lac mesh sizes, for same conditions, so i am getting negative results for 2.5 lac, 3 lac & positive answer for 3.5 lac, 4 lac meshes. please suggest me where i am doing wrong, in that negative results i am getting as compressor performance results.
|
|
April 10, 2014, 07:18 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,700
Rep Power: 143 |
FAQ: http://www.cfd-online.com/Wiki/Ansys..._inaccurate.3F
Please do not post the same question on multiple threads. I have deleted the duplicate posts. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with torque output from a turbine simulation. | pa-dundas | FLUENT | 5 | July 17, 2022 05:27 |
Air Flow Analysis around a Wind Turbine | NightHawkRaven | FLUENT | 4 | August 12, 2014 17:18 |
simulating a wind turbine | s.q | FLUENT | 1 | October 17, 2013 08:11 |
FSI - Wind Turbine | AUN | CFX | 13 | August 29, 2012 16:44 |
Boundary condition setting regarding turbine simulation using CFX | Lacerlacer | CFX | 11 | March 12, 2012 09:32 |