|April 18, 2014, 03:47||
Exporting data of transient simulation DURING a simulation, at user locations ?
Join Date: Dec 2013
Location: Montenegro, Serbia
Posts: 28Rep Power: 4
I am running a transient rotor CFX computation of fan flow, so a transient simulation. As far as I managed to get it, in CFX, I can only export my data during a simulation in the geometrical locations recognized by CFX in my case, like interface area, inlet, outlet, or similar, defined during case set-uo & meshing. Say I wish to define my own surface or polyline, and export some data along that user defined loaction, during a simulation, or after. Seems like in CFX, you can only save your .trn data for each time step (select export..."every timestep"), and then process over all .trn data using a macro? That is what I did. BUT, in a large mesh, the .trn file is huge, and I don't need all information in every CV of the domain. So in this case it becomes a huge problem with disk space and processing as macro has to loop over full size .trn files.
In FLUENT, I was able to define a user location in FLUENT. Say a plane or similar, then set up a export during simulation in a .txt file of data I need along that geometrical location. Seems like it can not be done in CFX?
Would be handy if CFX could recognize a geometrical location the user generated in the CFD Post (after 1 iteration or 1 timestep) and allow the user to export some specified data only, at that location, by recognizing it under "export data menu" in CFX, instead of saving full .trn files.
Any help is appreciated
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem in initializing transient simulation with a finer mesh||sidd||CFX||8||April 29, 2016 02:25|
|2 datas on one plot||Akuji||ParaView||46||December 1, 2013 15:06|
|Transient simulations: how to tell its converged (I've read the FAQ & user guides!)||JuPa||CFX||10||March 12, 2013 10:02|
|Resume Transient simulation||HMR||CFX||1||June 28, 2011 21:13|
|transient simulation of a rotating rectangle||icesniffer||CFX||1||August 8, 2009 07:25|