Ansys CFX Post
 

Hello,

I have a radial compressor with inlet,diffusor and volute,
and made planes in CFD Post with different radius=const. so long no problem,
now i want to unwind the planes, so that i can see die whole plane with radius=const, with circumference over die height of the plane or conversely, that i can see the plane as a plate.

Thank you for help.
Ckern

I do not think CFD-Post can do this. I would export the data in the plane and take it into tecplot, paraview or some other post pocessing package and do it there.

Hi Christoph,

you should try the Turbo-mode. It is possible to do this there - the only problem is the definition of hub and shroud areas but it is possible and I did that already for a similar problem.