|December 10, 2014, 08:41||
spray formation with ANSYS CFX
Join Date: Dec 2014
Posts: 2Rep Power: 0
In our case we are modeling the spray formation in the cylinderical combustion chamber with Ansys CFX 15. A full cone spray with break up model and constant particle diameter have been defined.
Air as Continuous fluid and n-Heptane as Particle Transport FLuid have been defined.
Total time 2e-3 seconds with 1000 timestep studied and results in the CFD-Post have been visuallized.
The questions are:
-How to get ''mass'' of injected particles in the domain? for example at specific timestep and specific volume get the amount of mass. Not the massflow!
-'Number of Positions' is option to control number of injected particles. Based on concept of parcels, how is possible to get overview over real amount of particles and representetive amount of particles?
|ansyscfx15, injections, spray injection, spray modelling|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Calculation of the Governing Equations||Mihail||CFX||7||September 7, 2014 06:27|
|Ansys 13 CFX problem on LInux Opensuse 11.4||serendipity||CFX||10||August 7, 2012 03:24|
|How to use non-equilibrium thermal model for porous medium in Ansys CFX 13.0?||Chander||CFX||3||November 28, 2011 15:26|
|Compressible Flow in Ansys CFX||bcheruk||CFX||11||February 26, 2011 19:40|
|CFX bought by Ansys - good or bad?!||Pete||CFX||38||February 21, 2003 08:34|