Get pressure at some distance from inlet boundary

bejanyar · June 25, 2015, 07:22

hello,
I have a water pipe with a butterfly disk into it.
Of course there is no problem by getting pressure at inlet boundary.
How can i find pressure at a specific distance from inlet ???

ghorrocks · June 25, 2015, 08:12

Put a point, line or plane object where you like. Then calculation the areaAve or lineAve pressure, or just report the pressure (if a point).

bejanyar · June 25, 2015, 10:12

Thanks for your answer.
I created a new plane in geometry and placed it on where i want.
but in result how can i find it ??
i mean that i can choose inlet, outlet , disk and ... but how can i choose plane1??

bejanyar · June 25, 2015, 12:09

OK!
I found it.
It was in result section.

June 25, 2015, 07:22	Get pressure at some distance from inlet boundary	#1
bejanyar Member Hamidreza Bijanyar Join Date: Jun 2015 Posts: 40 Rep Power: 10	hello, I have a water pipe with a butterfly disk into it. Of course there is no problem by getting pressure at inlet boundary. How can i find pressure at a specific distance from inlet ???

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	58	July 3, 2020 01:13
UDF: Change boundary condition. Velocity inlet to pressure inlet at time "t"	jpina	FLUENT	10	April 11, 2015 14:19
Please help with flow around car modelling!	Tudor Miron	CFX	17	March 19, 2004 19:23
may I use Pressure inlet Boundary as free surface?	duci	FLUENT	0	August 23, 2002 22:29
what the result is negatif pressure at inlet	chong chee nan	FLUENT	0	December 29, 2001 05:13

June 25, 2015, 08:12		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,700 Rep Power: 143	Put a point, line or plane object where you like. Then calculation the areaAve or lineAve pressure, or just report the pressure (if a point).

June 25, 2015, 10:12		#3
bejanyar Member Hamidreza Bijanyar Join Date: Jun 2015 Posts: 40 Rep Power: 10	Thanks for your answer. I created a new plane in geometry and placed it on where i want. but in result how can i find it ?? i mean that i can choose inlet, outlet , disk and ... but how can i choose plane1??

June 25, 2015, 12:09		#4
bejanyar Member Hamidreza Bijanyar Join Date: Jun 2015 Posts: 40 Rep Power: 10	OK! I found it. It was in result section.