Periodic or full circle modell?

Roland R · October 12, 2015, 12:54

Hello,

I have two rings which are in rotating. The inner ring is in contact with the outer ring by a thin tube:

A képet a Képfeltöltés.hu tárolja. http://www.kepfeltoltes.hu

In the real, these rings ar very thin , it will have very high element number mesh, so I would like to calculate it with periodic boundary conditions. (with a 10degree model for example). But there is the tube between the rings...

Could you give any suggestions to solve it? Can I use the periodic BC with the using of tube too?

Thanks
Roland

ghorrocks · October 12, 2015, 19:32

What is the flow doing?

But on the face of it this flow does not look periodic so you will have to model the whole thing.

When you have long thin features like this you use hex meshes where you can stretch the mesh in the long dimension. That keeps your mesh a manageable size.

Roland R · October 13, 2015, 05:16

The real geometry is the flow field of a hydarulic clutch. The model (attached to this topic) is a simplefied geometry.

By the way, I agree with you fully. I had a discussion one of my colleagues in this issue, and I would like to have a confirmation from an expert CFD user.

Thanks a lot Glenn!

Roland

October 12, 2015, 12:54	Periodic or full circle modell?	#1
Roland R Senior Member Roland Rakos Join Date: Mar 2009 Posts: 131 Rep Power: 17	Hello, I have two rings which are in rotating. The inner ring is in contact with the outer ring by a thin tube: A képet a Képfeltöltés.hu tárolja. http://www.kepfeltoltes.hu In the real, these rings ar very thin , it will have very high element number mesh, so I would like to calculate it with periodic boundary conditions. (with a 10degree model for example). But there is the tube between the rings... Could you give any suggestions to solve it? Can I use the periodic BC with the using of tube too? Thanks Roland

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Periodic mesh to Full mesh	shivasluzz	ANSYS Meshing & Geometry	0	October 5, 2015 12:01
How to create interface between periodic model and full model?	shivasluzz	CFX	2	October 5, 2015 11:36
Turbomachinery: Making periodic domain from a full domian	salehi144	ANSYS	0	November 1, 2014 10:21
How to view the full passage when only one passage is used with periodic condition?	huangxianbei	OpenFOAM Post-Processing	0	September 12, 2014 22:28
[ICEM] how to define periodic in icem ?	mingersai	ANSYS Meshing & Geometry	1	February 3, 2012 17:46

October 12, 2015, 19:32		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,700 Rep Power: 143	What is the flow doing? But on the face of it this flow does not look periodic so you will have to model the whole thing. When you have long thin features like this you use hex meshes where you can stretch the mesh in the long dimension. That keeps your mesh a manageable size.

October 13, 2015, 05:16		#3
Roland R Senior Member Roland Rakos Join Date: Mar 2009 Posts: 131 Rep Power: 17	The real geometry is the flow field of a hydarulic clutch. The model (attached to this topic) is a simplefied geometry. By the way, I agree with you fully. I had a discussion one of my colleagues in this issue, and I would like to have a confirmation from an expert CFD user. Thanks a lot Glenn! Roland