|December 12, 2015, 11:41||
boundary condition in double pipe heat exchanger
Join Date: Dec 2015
Posts: 10Rep Power: 2
I have been trying to simulate a double pipe heat exchanger using ansys CFX15.
in defining boundary condition, mass flow rate applies for both hot and cold inlet ,in this case results shows accurate values of outlet temperatures but shows incorrect results for surface heat transfer coeff.
On the other side, when velocity was applied for both inlets results shows accurate values of inner and outer surface heat transfer coeff but this time outlet temperatures shows incorrect value.
plizz help me i really confused ,
|Thread||Thread Starter||Forum||Replies||Last Post|
|Parallel User Defined Real Gas Model||aeroman||FLUENT||4||July 1, 2015 06:09|
|Radiation in semi-transparent media with surface-to-surface model?||mpeppels||CFX||10||June 16, 2015 15:48|
|Question about heat transfer coefficient setting for CFX||Anna Tian||CFX||1||June 16, 2013 06:28|
|An error has occurred in cfx5solve:||volo87||CFX||5||June 14, 2013 17:44|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|