|
[Sponsors] |
May 15, 2016, 17:33 |
ICEM OR TURBO-Grid
|
#1 |
New Member
AHMED LAOUARI
Join Date: May 2016
Posts: 2
Rep Power: 0 |
hi,
I would like to meshing runner blades, can you suggest the best software meshing between Icem and turbo-grid thanks |
|
May 16, 2016, 02:36 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,665
Rep Power: 143 |
The best software is the one you can use successfully to get the job done. So arrange a trial of both of them and give them a go at doing the task you need to do. Then you will find out for yourself which software is best for your task.
|
|
May 17, 2016, 03:40 |
|
#3 |
Senior Member
Maxim
Join Date: Aug 2015
Location: Germany
Posts: 415
Rep Power: 12 |
TurboGrid has a nicer GUI. In case you don't have any meshing experience, you will probably achieve results more quickly with TurboGrid.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[TurboGrid] Exporting mesh from Turbo grid in .msh format | Jack001 | ANSYS Meshing & Geometry | 0 | January 19, 2016 15:25 |
[Commercial meshers] turbo grid | amiri | OpenFOAM Meshing & Mesh Conversion | 1 | April 20, 2015 08:41 |
[TGrid] Generating Volume Mesh in ICEM and Generating Prism in T grid | hasanifte | ANSYS Meshing & Geometry | 0 | March 30, 2015 16:48 |
[ICEM] Structured grid without blocking in ICEM | BahaZero | ANSYS Meshing & Geometry | 19 | March 5, 2013 12:36 |
a question about generating grid used by icem | sweet0575 | CFX | 1 | April 14, 2009 00:31 |