Injection Direction of Particles

cfd seeker · August 19, 2016, 12:14

Hello mates,

I have a very simple question regarding the Injection Direction of Spray in CFX for the case of Full Cone Spray. What does this Injection Direction basically corresponds to in case of Full Cone Spray? Is it the angle at which Injector is oriented w.r.t to its mounting plane or is it something else? How I can determine Injection Direction of particles in case of Multiple Hole Injection?

Thanks

Best Regards

cfd seeker · August 23, 2016, 08:01

Anyone please, Gorrocks do you have any idea?

ghorrocks · August 23, 2016, 20:07

I can't help you as I do not know that model very well. All I can recommend is to read the documentation and to do some test simulations where you adjust parameters and see what they do.

August 19, 2016, 12:14	Injection Direction of Particles	#1
cfd seeker Senior Member Join Date: Mar 2011 Location: Germany Posts: 552 Rep Power: 20	Hello mates, I have a very simple question regarding the Injection Direction of Spray in CFX for the case of Full Cone Spray. What does this Injection Direction basically corresponds to in case of Full Cone Spray? Is it the angle at which Injector is oriented w.r.t to its mounting plane or is it something else? How I can determine Injection Direction of particles in case of Multiple Hole Injection? Thanks Best Regards

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DPM UDF Injection leads to 2 different particles	sega	Fluent UDF and Scheme Programming	4	December 28, 2017 22:57
FLUENT-DEM particle injection	Clarence91	FLUENT	0	July 28, 2014 12:14
Setup for different velocities of particles injection	mxylondon	OpenFOAM	1	August 5, 2013 04:01
injection problem	Mark New	FLUENT	0	August 4, 2013 01:30
On DPM injection properties.	akr	FLUENT	4	October 23, 2006 10:54

August 23, 2016, 08:01		#2
cfd seeker Senior Member Join Date: Mar 2011 Location: Germany Posts: 552 Rep Power: 20	Anyone please, Gorrocks do you have any idea?

August 23, 2016, 20:07		#3
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	I can't help you as I do not know that model very well. All I can recommend is to read the documentation and to do some test simulations where you adjust parameters and see what they do.