|
[Sponsors] |
August 22, 2016, 12:18 |
fsi simulation-convergance question
|
#1 |
Member
SMN
Join Date: Jun 2009
Location: CANADA
Posts: 71
Rep Power: 16 |
I am simulationg 3D transient fsi around a hydrofoil. Among all the time steps, there are only a few in the middle of my simulation which are not fully converged in the interface-loads. (i mean the convegence value of the interface loads is not negative)
Do you think it is important? if yes, what is the solution? I have decreased the time step (Courant=5) but still the same issue. Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question: mesh.update() in FSI | pi06jl6 | OpenFOAM Programming & Development | 46 | February 21, 2016 05:06 |
My FSI simulation (pipe-flow) | vitorspadeto | OpenFOAM Programming & Development | 1 | September 24, 2014 17:27 |
Question about starting the simulation automatically one after another by Fluent | Anna Tian | FLUENT | 1 | January 23, 2014 19:23 |
FSI simulation is DEAD SLOW | Lance | CFX | 6 | September 12, 2009 09:00 |
FSI Simulation unsing ANSYS Multifield | k_buz | CFX | 2 | April 6, 2009 17:40 |