|May 4, 2000, 02:23||
The impeller library
Dear CFX users,
I am trying to build a standard 6 blade Rushton impeller by using the Impeller Library in CFX 4.3. My problem is not symmetrical so the full 360o will be modelled. I have no problem generating the full 6 blades by copy with rotation of one blade created from the library. But when I came to use JOIN ALL option, an error message stating constraints have been applied in conflicting locations was shown, which restrained me from generating the grids. I am a new CFX user so I wonder if anyone here could offer some help. I'd greatly appreciate it.
Also, I've created a cylindrical tank using Cartesian coordinates then converted into cylindrical ones. Later I need to insert a dip-pipe, as a gas injection duct, into the computational domain that remains stationary in a sliding mesh method. I am reluctant to set patches of thin surface to define the duct as it would not be round pipe! Does anybody have a better idea to resolve this problem??
Many thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|problem loading UDF library in parallel cluster||Veera Gutti||FLUENT||8||July 26, 2016 07:24|
|Having a few problems in simulating a rotating impeller||ajinsan||CFX||12||February 4, 2016 17:10|
|Simulation of an Axial Impeller||cnchilavert||CFX||1||October 15, 2011 02:01|
|OpenFOAM141dev linking error on IBM AIX 52||matthias||OpenFOAM Installation||24||April 28, 2008 15:49|
|Help! I cann't make library||Bowling||FLUENT||5||May 12, 2004 04:56|