Home > Forums > Software User Forums > ANSYS > CFX

mesh generation for swirl burner on wall fire

Mark Forums Read

Reply

Search this Thread

July 14, 2000, 09:55	mesh generation for swirl burner on wall fire	#1
xfshi Guest Posts: n/a	Hi, guys: Could I share your experince of mesh generation for swirl burner on wall fire furnace.Thanks in advance xfshi

July 16, 2000, 06:23	Re: mesh generation for swirl burner on wall fire	#2
Li Xinfeng Guest Posts: n/a	I think it's very complex using the cfx-build, YOu can try the gridgen or icemcfd.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
slow after mesh for enhanced wall treat DPM	joshkemp	FLUENT	0	May 1, 2007 17:20
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10
3-d elliptic generation mesh	Gang Sun	Main CFD Forum	5	September 16, 1998 00:24

All times are GMT -4. The time now is 13:48.