CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > Software User Forums > ANSYS > CFX

Transient Boundary Conditions-Source Code Intrface

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old   March 7, 2001, 11:13
Default Transient Boundary Conditions-Source Code Intrface
  #1
Tascflow User
Guest
 
Posts: n/a
Hello,

I am having a problem using the transient boundary condition subroutine in CFX-TASCFlow 2.10.

- I initially setup my problem in tascgrid to define my domain and grid.

- I am just modelling conduction through a CHT solid.

- I created an inactive zone between the CHT and the Fluid so that the two do not interact.

- I then used the GUI to define my Zones & Attributes and Boundary Conditions.

- Before I defined the 2-d face to which the transient B.C. was to be applied to, I followed the user manual, in that I copied the subroutine to a directory within my problem directory. I modified the subroutine to match my problem. After that I went back to my UNIX prompt and typed in

%tascflow3d -local code

I received no error messages after this command, but when I checked the subroutine directory, I did not see the tascflow3d executable "tascflow3d_local" that the user manual says should appear.

When I went back to the GUI, to apply the transient boundary condition, it asked me for the key number, which I supplied. It then brought up a tascbob3d command window where it again asked me for the key number and the region to which it was to be attached to. After I entered this I closed the box and when it went back to the GUI, the Boundary Condition window reverted back to a steady state b.c..

If there is any help you can give, I would greatly appreciate this
  Reply With Quote

Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
[swak4Foam] swak4foam building problem GGerber OpenFOAM Community Contributions 54 April 24, 2015 17:02
Boundary conditions for 2D Navie-Stockes simulation L1011 OpenFOAM 5 December 13, 2012 09:17
natural convection mehrdadeng CFX 10 February 25, 2011 06:25
Transient boundary conditions Javier Main CFD Forum 1 November 12, 2004 05:54
A problem about setting boundary conditions lyang Main CFD Forum 0 September 19, 1999 19:29


All times are GMT -4. The time now is 20:31.