|
[Sponsors] |
May 30, 2001, 07:49 |
Problem in using Build 4
|
#1 |
Guest
Posts: n/a
|
I am interested in CFD analyses of bodies of revolution using CFX 4.3.But when I revolve the governing curve to generate the body of revolution ,the surface formed was not suitable for structured meshing because it has three bonding curve of the surface. So the isomesh fails. Is there any effect of using RECT. ,CYLIDERCAL, coordinates. Is there any option such as zero connector, I mean curve of zero length
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 20:42 |
OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 09:48 |
Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 06:29 |
Build problem | Jeff | CFX | 0 | July 31, 2003 14:21 |
CFX4.3 Build problem | cfx4.3 user | CFX | 4 | January 2, 2003 15:18 |