PLOT3D for TascFlow

July 5, 2001, 16:50

Hi, Is there anyway for Tascflow to read PLOT3D mesh? Does anyone has the converter routine for it?

Thanks.

Alan

July 5, 2001, 21:52

Hi Alan,

Use TASCu2s to convert Plot3D and others into TASCflow grd format. It is accessible from the tools menu on the launcher or the TASCflow GUI.

TASCu2s can also be used to re-block existing meshes, reducing the number of blocks to a the minimum required for the given topology. Reducing the number of blocks can significantly reduce computational effort.

Regards, Robin

July 5, 2001, 16:50	PLOT3D for TascFlow	#1
Alan M. Shih Guest Posts: n/a	Hi, Is there anyway for Tascflow to read PLOT3D mesh? Does anyone has the converter routine for it? Thanks. Alan

July 5, 2001, 21:52	Re: PLOT3D for TascFlow	#2
Robin Steed Guest Posts: n/a	Hi Alan, Use TASCu2s to convert Plot3D and others into TASCflow grd format. It is accessible from the tools menu on the launcher or the TASCflow GUI. TASCu2s can also be used to re-block existing meshes, reducing the number of blocks to a the minimum required for the given topology. Reducing the number of blocks can significantly reduce computational effort. Regards, Robin

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Mapping plot3d data	Fransje	OpenFOAM Pre-Processing	2	July 13, 2010 06:02
Plot3D to CFX post-processor?	bg2k6	CFX	2	September 26, 2009 21:06
PLOT3D Equations	Alfonso Villanueva	Main CFD Forum	1	June 23, 2005 16:51
Gambit - PLOT3D	Danny Tan	FLUENT	0	December 26, 2001 00:43
Plot3d grids > Gambit > Fluent 5	David C	FLUENT	1	February 16, 2001 16:29