CFX-5 on NT

October 3, 2001, 02:46

Hellow

I was wondering to ask if any of you knows if CFX-5 can operate also on windows 2000 profesional edition (service pack 1) again using exceed 6.2 and exceed3D 6.2.

Thanks in advance

Constantinos

October 3, 2001, 12:23

Hi Constantinos,

CFX-5.4.1 is not officially supported on Win2K, but you should be able to run it without difficulty. You will need Exceed 6.2 or 7.0 for Build, but the other components do not need it. The only issue you may find is that you have to remove the quotes around the Exceed reference in you PATH environment variable.

CFX-5.5 will be supported on Win2K and no longer needs Exceed.

Robin

October 3, 2001, 02:46	CFX-5 on NT	#1
Constantinos Guest Posts: n/a	Hellow I was wondering to ask if any of you knows if CFX-5 can operate also on windows 2000 profesional edition (service pack 1) again using exceed 6.2 and exceed3D 6.2. Thanks in advance Constantinos

October 3, 2001, 12:23	Re: CFX-5 on NT	#2
Robin Steed Guest Posts: n/a	Hi Constantinos, CFX-5.4.1 is not officially supported on Win2K, but you should be able to run it without difficulty. You will need Exceed 6.2 or 7.0 for Build, but the other components do not need it. The only issue you may find is that you have to remove the quotes around the Exceed reference in you PATH environment variable. CFX-5.5 will be supported on Win2K and no longer needs Exceed. Robin

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Proper way to name boundaries on 2D model for use in CFX?	RossFS	ANSYS Meshing & Geometry	4	November 10, 2011 02:38
Pros and Cons for CFX, CFdesign, COMSOL	Val	Main CFD Forum	3	June 10, 2011 02:20
CFX pressure in Simulations problem	nasdak	CFX	1	April 14, 2010 13:22
PhD using CFX	Rui	CFX	9	May 28, 2007 05:59
CFX 4.4 installation problem	Pandu Sattvika	CFX	1	December 1, 2001 04:07