|
[Sponsors] |
October 22, 2001, 07:13 |
airfoil setup
|
#1 |
Guest
Posts: n/a
|
Dear all
I have been using Fluent for the last 3 months however, due to certain reasons I am now starting to use CFX to model the same problems. I wondered if anybody could give advise on where to get information for setting up an airfoil and calculating all the usual stuff, like lift, drag, centre of pressure, separation, and transition. If you know of papers on this subject that describe the set-up and the type of mesh needed, especially for CFX it would be much appreciated. Cheers Andy |
|
October 22, 2001, 14:15 |
Re: airfoil setup
|
#2 |
Guest
Posts: n/a
|
Hi Andy,
If you search for "airfoil" on the CFX website you will get several links. Check out: Prediction of Airfoil Characteristics for Wind Turbines Blades with CFX Alois P. Schaarczyk Laboratory for Computational Mechanics Mechanical Engineering Department University of Applied Sciences Kiel http://www.software.aeat.com/cfx/ili...haffarczyk.pdf Best regards, Robin |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
Low Speed Airfoil | Mancusi | FLUENT | 7 | April 3, 2014 06:11 |
Modeling Backflow for a 3D Airfoil (Wing of Finite Span) | Josh | CFX | 9 | August 18, 2009 11:31 |
Airfoil boundary condition | Frank | Main CFD Forum | 1 | April 21, 2008 18:36 |
Turbulent airfoil setup | pvtpilot | OpenFOAM Running, Solving & CFD | 5 | July 2, 2007 19:14 |