|November 13, 2001, 00:57||
Help! Free waterjet simulation
I am trying to use CFD and am inexperienced with it. Can anyone with experience in modelling free water jets help me?
I am using CFX5.4.1 to model a axisymmetry water jet after it coming through a very fine nozzle(1 mm). I am going to know the jet's velocity and pressure distribution when it sprays in air atmosphere. The jet got high velocity (900m/s) and pressure (350 MPa).
I use a three-dimensional computational domain. i.e. a vertical 10mm diameter cylinder of length 100 mm. The water jet enters domain on the top of cylinder.
This problem is considered as steady state, highly turbulent and two-phase (air and water). The air is assumed to form a continuous phase and the water is to form a disperse phase.
At jet_inlet boundary, I put same velocity but different volume fraction for tow phase, i.e. water_speed= 900m/s, water_vf=1, air_speed =900 m/s, air_vf=0
I set the initial phase distribution to air 100% and water 0%.
I could not get a convergence solution of my model. What are the reasons?
Could I use multiphase model in this simulation? I know that CFX5 does not support continuous-continuous multiphase calculations. But the two phases I got here are both continuous.
Please help me! Thanks in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Resume Transient simulation||HMR||CFX||1||June 28, 2011 21:13|
|Free fall body simulation||velan||OpenFOAM Running, Solving & CFD||5||July 31, 2010 13:23|
|Simulation of a free falling wedge into water 2D||nico765||OpenFOAM Running, Solving & CFD||3||January 11, 2009 02:47|
|Can I have solid in the free surface simulation?||ggbaby||CD-adapco||0||September 5, 2006 05:45|
|free surface flow simulation||Fernando Mancebo-Ordonez||Main CFD Forum||2||December 3, 1999 10:59|