|
[Sponsors] |
December 17, 2001, 11:16 |
CFX on NT ...
|
#1 |
Guest
Posts: n/a
|
Hi,
Is there anyone to give me some information for CFX on NT. If anyone can provide the system requirement, it will be great... Thanks, Sinjae |
|
December 17, 2001, 15:26 |
Re: CFX on NT ...
|
#2 |
Guest
Posts: n/a
|
Hi Sinjae, We are running three CFX codes here in NT Operating System, CFX-4, CFX-5 and CFX-Tascflow, all codes are doing well. About system requirement, with the actual technology you don't need to worry about, as long as you have a minimum of 256Mb RAM and 5Gb of hard disk available for your system and a PENTIUM 266MHz. Today, I believe that is very hard to find a brand new PC slower than that I've mentioned.
Regards, cfd guy |
|
December 18, 2001, 06:02 |
Re: CFX on NT ...
|
#3 |
Guest
Posts: n/a
|
Hi Sinjae
All relevant system requirement are available on cfx homepage : http://www.software.aeat.com/cfx/ Select the product at then the requirement Regards Michael |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Proper way to name boundaries on 2D model for use in CFX? | RossFS | ANSYS Meshing & Geometry | 4 | November 10, 2011 03:38 |
Pros and Cons for CFX, CFdesign, COMSOL | Val | Main CFD Forum | 3 | June 10, 2011 03:20 |
CFX pressure in Simulations problem | nasdak | CFX | 1 | April 14, 2010 14:22 |
PhD using CFX | Rui | CFX | 9 | May 28, 2007 06:59 |
CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 05:07 |