Home > Forums > Software User Forums > ANSYS > CFX

CFX-build: modelling from a set of parts?

Mark Forums Read

Reply

Search this Thread

March 26, 2002, 05:55	CFX-build: modelling from a set of parts?	#1
Dennis Johansson Guest Posts: n/a	Hi, I'm a student that just started to use CFX 4.4 in a project. I'm wondering if there is a simple way to make a modell where it is easy to try new configurations. For example is it possible to read more then one geometry file into the solver. All help is appreciated Regards, Dennis

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to set environmental variables of Intel Fortran +CFX?	Christine MO	CFX	0	September 23, 2011 11:11
Axial impeller modelling in CFX	famarcfd	CFX	5	June 14, 2011 18:45
CFX Cable Tunnel Modelling	ibrahim.mohamed	CFX	4	May 3, 2010 07:49
Reg : Modelling of Gasification Using CFX	S.SIVAKUMAR	CFX	0	June 4, 2008 03:47
Fan Modelling Problem in CFX	Jenny	CFX	8	September 11, 2007 13:59

All times are GMT -4. The time now is 06:45.