 |
 |
 |
|
|
|
[Sponsors] | ||||
April 4, 2002, 04:54
|
Parallel computation problem in Tascflow
|
#1 |
|
Guest
Posts: n/a
|
Dear all CFX users,
Does anyone have experience on parallel computation by using of cfx-tascflow. What I was doing is a problem about simulation of transient Rotor/Stator. Every time I tried to run it on a parallel model the system is stoped due to memory insufficent. Actually, my computer possess enough memory to do this work when I run it on a serial model. Does anyboy can help me on it?I will look forward to your responses. Best regards, Dandy |
|
|
||
|
April 4, 2002, 19:53
|
Re: Parallel computation problem in Tascflow
|
#2 |
|
Guest
Posts: n/a
|
Not enough REAL workspace in "GENGRP".
In order to recover, set the following parameters in the PRM file: GGI_RESTART = F SLIDING_RS_START_THETA = 0.2011082E+02 SLIDING_RS_MEMORY_FACTOR > 1.0 Make sure that these parameters are deleted from the PRM file for subsequent simulations (post-recovery) |
|
|
|
||
|
April 18, 2002, 10:56
|
Re: Parallel computation problem in Tascflow
|
#3 |
|
Guest
Posts: n/a
|
Just increase the memory settings you are using. Memory required for parallel is a little different than serial.
|
|
|
|
||
|
April 21, 2002, 00:32
|
Re: Parallel computation problem in Tascflow
|
#4 |
|
Guest
Posts: n/a
|
But it still doesn't work......
|
|
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| problem using property udfs in parallel mode | EllenW | Fluent UDF and Scheme Programming | 5 | July 10, 2009 04:31 |
| Fluent parallel license problem | brothershuai | Main CFD Forum | 0 | July 1, 2009 15:41 |
| problem using property udfs in parallel mode | EllenW | FLUENT | 0 | June 23, 2009 17:18 |
| transient, parallel - problem with timestep | Peter | CFX | 5 | March 8, 2005 16:15 |
| CFX-5.7 MPICH Parallel Problem (Output of Results) | James Date | CFX | 7 | February 15, 2005 16:03 |
Linear Mode
