|
[Sponsors] |
April 30, 2002, 09:12 |
Precission in output file
|
#1 |
Guest
Posts: n/a
|
Hello
We wish to use the print function to print all variables to the output file in CFX 4.4. When doing so we find that the precission on the variables is only three significant digits. Is it possible to print with a greater precission?? Regards Thomas |
|
April 30, 2002, 16:33 |
Re: Precission in output file
|
#2 |
Guest
Posts: n/a
|
Yes,
You can use the USRTRN subroutine and extract all data that you want. Inside this routine you can use one of two another subroutines available: IPALL for values in several patches or blocks; or IPREC for values in a single block or patch. There's some examples in the manual. Once you extracted the data you can print it in your desired format. Good Luck, cfd guy |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
pisoFoam compiling error with OF 1.7.1 on MAC OSX | Greg Givogue | OpenFOAM Programming & Development | 3 | March 4, 2011 17:18 |
ParaView Compilation | jakaranda | OpenFOAM Installation | 3 | October 27, 2008 11:46 |
DxFoam reader update | hjasak | OpenFOAM Post-Processing | 69 | April 24, 2008 01:24 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |