|
[Sponsors] |
May 6, 2002, 06:36 |
Calculation of cell areas in USRTRN
|
#1 |
Guest
Posts: n/a
|
Hi !
I've a encountered a problem in finding the area of a cell when using USRTRN I need to calculate the area of each gridcell in for example the j direction. How do adress this? So far I've tried the area(Nface,3) command, but I'm, not quite sure that I've done it right. Søren |
|
May 7, 2002, 11:59 |
Re: Calculation of cell areas in USRTRN
|
#2 |
Guest
Posts: n/a
|
Hi,
I believe that the easiest way is to create an USER2D patch under your meshing tool. Once you've created this patch you can use IPALL (or IPREC) to extract the data that you want. Good luck, cfd guy |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FvMatrix coefficients | shrina | OpenFOAM Running, Solving & CFD | 10 | October 3, 2013 14:38 |
gradient calculation of cell centered finite volume method | zhengjg | Main CFD Forum | 10 | November 11, 2012 23:13 |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |