|
[Sponsors] |
May 6, 2002, 13:44 |
Build 5.5 error message
|
#1 |
Guest
Posts: n/a
|
in CFX 5.5 Build i got the following erro message: "Problem: The original model has incorrectly oriented faces."
Should I recreate my whole geom, or what?????? Cos I got a lotta surfaces/solids/etc THX Bogdan |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Different Results from Fluent 5.5 and Fluent 6.0 | Rajeev Kumar Singh | FLUENT | 6 | December 19, 2010 11:33 |
64bitrhel5 OF installation instructions | mirko | OpenFOAM Installation | 2 | August 12, 2008 18:07 |
OpenFOAM build from source instructions | tj22 | OpenFOAM Installation | 7 | April 6, 2006 16:15 |
ellipse in Build 5.5 | Eve | CFX | 1 | March 25, 2003 16:24 |
Edit surface in Build 5.5 | Bogesz | CFX | 1 | May 2, 2002 09:15 |