CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   Meshing error (http://www.cfd-online.com/Forums/cfx/19011-meshing-error.html)

Peter June 8, 2002 07:31

Meshing error
 
Hi I have imported a iges file into mesh only mode. But when I try to mesh I get the following error:

Fatal Error: Face evaluation failed

Error: ------

face evaluation failed error status code: 2 Surface 2187

Does anyone have an idea ???

Thanx.

regards

Peter

henry June 10, 2002 07:08

Re: Meshing error
 
hi

there is one way to eliminate this,use the parasolid otion while exporting ,and if you are not able to do this then while expoting to iges check on the tolerance and then try to increase it by a tenth,

but I'd say parasolid is any day a better choice.

henry


All times are GMT -4. The time now is 13:04.