|
[Sponsors] |
August 12, 2002, 23:16 |
outlet of boundary
|
#1 |
Guest
Posts: n/a
|
Dear CFX 5.5 Users, I have a model with one outlet . I want outlet neither press nor velocity,or not degassing condition.Can I set fluid full developing at outlet,that is the fluid flowing one coordinate.What can I do for it?Thanks for answer!
|
|
August 13, 2002, 12:29 |
Re: outlet of boundary
|
#2 |
Guest
Posts: n/a
|
Hi!
You can set Average Pressure. But in this case the problem become less conditioned. LEGO |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Outlet boundary condition for wave flume with interFoam solver | Arnoldinho | OpenFOAM | 9 | July 10, 2018 05:15 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Combining BCs: wall - outlet. Boundary layer disappears | MartinaF | OpenFOAM Running, Solving & CFD | 1 | July 20, 2009 18:14 |
Implications for heat transfer when outlet pressure boundary condition used | Blob | CFX | 2 | March 26, 2009 06:22 |
Inlet & Outlet Boundary Conditions | dhananjay | Main CFD Forum | 0 | December 18, 2006 02:51 |