CFD Online Logo CFD Online URL
www.cfd-online.com
[Sponsors]
Home > Forums > CFX

Unmatched boundary

Register Blogs Members List Search Today's Posts Mark Forums Read

Reply
 
LinkBack Thread Tools Display Modes
Old   August 15, 2002, 06:17
Default Unmatched boundary
  #1
nyatoto
Guest
 
Posts: n/a
The CFD family,

I am have read somewhere in the manual that if I have unmatched boundary then I should not submit my work to VOLMSH with the the REBLOCK toggled on, in the Analysis of CFXBuild4.4. However, I have done the contrary and yet my simulation results compare quite welll with experimental data. Why is this so?? I want be certain that my results are not just a fluke!

Any idea please!

Regards nyatoto
  Reply With Quote

Old   August 15, 2002, 18:36
Default Re: Unmatched boundary
  #2
Glenn Horrocks
Guest
 
Posts: n/a
Hi Nyatoto,

The reason is after equivalencing the nodes, if any elements match up on either side of the unmatched interface the reblocker will think it is a block, and hence will construct a block which crosses the unmatched grid interface.

If this happens, the solver will bomb out with an unmatched grid error. If you didn't get this error (and it sounds like you didn't), then there should be no problem with your simulation.

Glenn
  Reply With Quote

Old   August 16, 2002, 03:32
Default Re: Unmatched boundary
  #3
nyatoto
Guest
 
Posts: n/a
Hi Glenn,

Thanks for you response. What you say really makes sense.

I did receive a warning when VOLMSH was creating the geo file and it says, "UNMATCHED BOUNDARY NAMES WILL CHANGE". I ignored this warning.

Now here are three other things I do not understand:

1. When I read the geo file in the RUN SETUP I did notice this: PATCHES: <INTER BLOCK BOUNDARY PATCH NOT DISPLAYED>

Now I ask not displayed but is it there??

2. When I browsed the OUT PUT FLILE I saw that the names of the unmatched boundary were just as I had specified in the BUILD.

3.Looking at the results in the POST PROCESS (ANALYSE), I saw that the unmatched boundaries appear as I had specified.

So the unmatched boundary names appear everywhere except in the geo file, and VOLMSH tells me that they will be renamed!!!

regards Nyatoto

  Reply With Quote

Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Wind turbine simulation Saturn CFX 34 October 16, 2014 05:27
Implementation of boundary conditions for FVM Tom Main CFD Forum 7 August 26, 2014 05:58
transient simulation of a rotating rectangle icesniffer CFX 1 August 8, 2009 07:25
Boundary conditions? Tom Main CFD Forum 0 November 5, 2002 02:54
Boundary Conditions Jan Ramboer Main CFD Forum 11 August 16, 1999 08:59


All times are GMT -4. The time now is 04:08.