How to Model Three Phase Clay Slurry in CFX 5.5

August 26, 2002, 23:52

Hello everyone,

I would like to model the movement of the clay slurry in the thickener. The clay slurry consists of at least three fluids: dispersed solid phase --sand, dispersed solid phase -- clay and continuous phase of water. In CFX 5.5.1 at most two fluids can be modelled. So anyone know how I can resolve this problem.

Thanks in advance!

J.Yang

August 27, 2002, 14:51

Actually, you should be able to set up N phase problems in 5.5.1. Where does CFX-Build say you can't?

Neale

August 28, 2002, 12:06

Thank you. I got it.

J.Yang

August 26, 2002, 23:52	How to Model Three Phase Clay Slurry in CFX 5.5	#1
J.Yang Guest Posts: n/a	Hello everyone, I would like to model the movement of the clay slurry in the thickener. The clay slurry consists of at least three fluids: dispersed solid phase --sand, dispersed solid phase -- clay and continuous phase of water. In CFX 5.5.1 at most two fluids can be modelled. So anyone know how I can resolve this problem. Thanks in advance! J.Yang

August 27, 2002, 14:51	Re: How to Model Three Phase Clay Slurry in CFX 5.	#2
Neale Guest Posts: n/a	Actually, you should be able to set up N phase problems in 5.5.1. Where does CFX-Build say you can't? Neale

August 28, 2002, 12:06	Re: How to Model Three Phase Clay Slurry in CFX 5.	#3
J.Yang Guest Posts: n/a	Thank you. I got it. J.Yang

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to access only one phase in multiphase model by UDF	wersoe	Fluent UDF and Scheme Programming	1	January 4, 2017 07:11
[ICEM] Proper way to name boundaries on 2D model for use in CFX?	RossFS	ANSYS Meshing & Geometry	4	November 10, 2011 02:38
Flash Process / Problem with thermal phase change model	Ridley	CFX	0	July 21, 2010 07:57
Problems bout CFD model of biomass gasification, Downdraft gasifier	wanglong	FLUENT	2	November 25, 2009 23:27
How to model the solid-fluid phase change in CFX	ohrmond	CFX	2	May 26, 2006 06:27