|
[Sponsors] |
December 23, 2010, 17:29 |
fluid pair models
|
#1 |
Member
sara
Join Date: Sep 2010
Posts: 33
Rep Power: 15 |
hi
i am modeling a domain with 3phases ( i.e. air+water+sediment). for defining model, i selected continues fluid for air and water and dispersed fluid for sediment in basic setting. in this state cfx want viscosity for sediment. what should i select it? in fluid pair models tab, should i select free surface for air/water and particle model for water/sediment in interface transfer option ? in experimental model, sediment don't move but in modeling with cfx sediment go out from end of channel. what is cause of it while velocity is same in both model? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
What is the total energy for incompressible fluid? | Harry Dong | Main CFD Forum | 12 | February 4, 2006 00:55 |
My Revised "Time Vs Energy" Article For Review | Abhi | Main CFD Forum | 2 | July 9, 2002 09:08 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |