 |
 |
 |
|
|
|
[Sponsors] | ||||
September 30, 2002, 03:23
|
Mean vel. or RMS Vel.?
|
#1 |
|
Guest
Posts: n/a
|
Hi All,
I am a new CFD user. Are the velocity calues calculated by the solver RMS velocities or mean velocities? How about the commonly published LDV velocity values? Should I expect that if these velocities are high then the turbulent KE is also high? I am aware that KE is calculated from RMS vel (eg in K-E model etc). Please shed light on this. You input is highly appreciated. Thanks Nathan |
|
|
||
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RMS P-mass no-convergence for low pressure ration,low rotor speed turbine | Ton | CFX | 3 | November 6, 2010 06:21 |
| Need Help Understanding RMS residual calculation | TWaung | CFX | 1 | September 22, 2009 18:21 |
| RMS Res. is the smaller the best? | Anderson T F | CFX | 10 | September 12, 2007 05:59 |
| Urgent help: RMS problem!!! | Anh | CFX | 4 | September 8, 2007 13:47 |
| What's wrong with my RMS profile in LES | Jiang Ning | FLUENT | 0 | March 31, 2005 05:30 |
Linear Mode
