Cut-out holes

December 10, 2002, 02:47

I am trying to create a similar geometry as in tutorial 13. First of all I create a pipe, then use the methods as in tutorial 1 or tutorial 4 to create the cut-out holes. But when I create the solid, there's a warning message to tell me to use "Edit---Surface---Edage match". What's the reason and how to create it? Thanks

David

January 18, 2003, 21:16

I think may be the problem occured because a surfaces you chose to be a boundary representation for created a solid were not closed. They should be a close surfaces. If they are not, The program will see a gab between a surfaces.Try to re-check your B-rep first.

Good luck ^_^ Jackie

January 18, 2003, 21:25

In addition, it's possible that you missing the surface that you want to cut it out in the trim surface step, ensure that you already chose the surface you like to trim too.

jackie

December 10, 2002, 02:47	Cut-out holes	#1
David Guest Posts: n/a	I am trying to create a similar geometry as in tutorial 13. First of all I create a pipe, then use the methods as in tutorial 1 or tutorial 4 to create the cut-out holes. But when I create the solid, there's a warning message to tell me to use "Edit---Surface---Edage match". What's the reason and how to create it? Thanks David

January 18, 2003, 21:16	Re: Cut-out holes	#2
Jackie Guest Posts: n/a	I think may be the problem occured because a surfaces you chose to be a boundary representation for created a solid were not closed. They should be a close surfaces. If they are not, The program will see a gab between a surfaces.Try to re-check your B-rep first. Good luck ^_^ Jackie

January 18, 2003, 21:25	Re: Cut-out holes	#3
Jackie Guest Posts: n/a	In addition, it's possible that you missing the surface that you want to cut it out in the trim surface step, ensure that you already chose the surface you like to trim too. jackie

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Tutorials] Tutorial of how to plot residuals !	wolle1982	OpenFOAM Community Contributions	171	February 20, 2024 02:55
Plotting Residuals	ata	OpenFOAM	12	July 8, 2011 02:50
[GAMBIT] most efficient mesh for a combustor with holes	perdita	ANSYS Meshing & Geometry	2	November 17, 2010 04:48
How to set up meshes of sparse and small holes?	leeyee	FLOW-3D	1	September 2, 2010 22:50
Flow through multiple holes	Matthew Markham	Main CFD Forum	3	January 28, 2009 21:47