|December 17, 2002, 12:56||
Can't see the line in Static Mixer problem.
Dear all, I am the newcomer of CFX. Now I am using CFX 5.5.1. My OS is Windows2000. After finishing the installation process, I follow the "Running the Example" section, in "Getting Started with CFX-5" of "Installing and Introduction to CFX-5" manual. The result is all right.
To practice using CFX, first, I follow the tutorial in "CFX-5 Tutorials". I follow the instruction in "Tutorial 1: Flow in a Stator Mixer" step by step. After following the step to create the first curve, in "Creating the Main Body", The result in output command is "$# 1 Curve Created: Curve 1". However I cannot see that curve. I tried to follow the succeeding steps, I also cannot see the second line. But it seems like CFX recognize that there is that curve.
I delete all files contain in the working folder, then restart my PC. Then try to do those steps. However I got the same result. I try to do many ways but the result is still the same.
However, today, I do the same step, and I get that curve this time. I do not know why. Then I am not sure if it will occur again or not.
Can anyone explain to me about this?
Thank you very much.
|Thread||Thread Starter||Forum||Replies||Last Post|
|error: uninitialized local variable 't' used||MASOUD||Fluent UDF and Scheme Programming||3||November 26, 2012 06:24|
|autoPatch error, mesh quality related...?||Alexvader||OpenFOAM||0||October 6, 2011 17:57|
|Meshing problem||Andrea_85||OpenFOAM||1||January 13, 2011 10:36|
|Problem of compilation OF 14Allwmake command not found||erik_d||OpenFOAM Bugs||13||September 13, 2008 21:45|
|line problem||popcool||FLUENT||1||December 12, 2002 13:04|