CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   How to specify a patch on a small hole (http://www.cfd-online.com/Forums/cfx/19450-how-specify-patch-small-hole.html)

allegro January 28, 2003 06:26

How to specify a patch on a small hole
 
Hi, everyone.

My calculation involve a very small hole of diameter 1.5mm on a wall of size 0.3m. Initially I specified a patch of name INLET2 on the surface of hole using CFX4.3 Build, but the patch did not appear in the generated .geo file. I must specify some inlet condition in this hole, how to create a patch in this case?

Thanks a lot.


All times are GMT -4. The time now is 21:15.