|February 14, 2003, 11:40||
adjust a range of target residuals shown on mass a
I'm using CFX5.5.1 and have a bit problem.
1. In Solver Manager, how can I adjust a range of target residuals shown on mass and momentum window? I set the target to 1e-008 but the range that show on the window are 1.0e+000 to 1.0e-006, so I cannot see the target residuals since the accummulate time-step is comparatively large
2. In CFX Post. I created a label of vector plot and it is always shown in vertical. How can I change it to horizontal ?
Thanks in advance, Jackie -_-'
|Thread||Thread Starter||Forum||Replies||Last Post|
|Building OpenFOAM1.7.0 from source||ata||OpenFOAM Installation||42||May 14, 2012 20:48|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|OpenFOAM14 for Mac OSX Darwin 104||gschaider||OpenFOAM Installation||118||July 20, 2008 05:19|
|Target mass flow rate||Saturn||FLUENT||0||December 10, 2004 05:18|
|Target Mass Flow Rate||Nitin||FLUENT||6||March 12, 2004 06:39|