 |
 |
 |
|
|
|
[Sponsors] | ||||
February 17, 2003, 04:33
|
set a source term to some specific area
|
#1 |
|
Guest
Posts: n/a
|
I'm using CFX551, I need to set a source term to some area between time steps, the source and the area is changing against time depending on the temperature and flow field in the previous time step. Can CEL be enough to do this? Or should I use FORTRAN subroutines? Please give me some advices, thanks in advance.
|
|
|
||
|
February 19, 2003, 04:51
|
a question on point source
|
#2 |
|
Guest
Posts: n/a
|
If 2 points share the same element, then the source is doubled or repleced by the latter?
|
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| wmake compiling new solver | mksca | OpenFOAM Programming & Development | 14 | June 22, 2018 06:29 |
| How to define a transient species source term? | aleisia | FLUENT | 3 | March 7, 2011 22:58 |
| pisoFoam compiling error with OF 1.7.1 on MAC OSX | Greg Givogue | OpenFOAM Programming & Development | 3 | March 4, 2011 17:18 |
| Two-Phase Buoyant Flow Issue | Miguel Baritto | CFX | 4 | August 31, 2006 12:02 |
| Unit for a source term | JP | CFX | 4 | July 14, 2005 14:29 |
Linear Mode
