Hi there,

I would like to postprocess the flow through a rectangular tube in its centerplane. The tube has a high aspect ratio (very long tube, very little diameter) and has been extracted from a paraboloid surface and is therefore twisted and also curved in space.

There is a lot of geometry from catia available but I found no appropriate way to make use of it and I wonder if I can make use of the boundaries of the domain to determine the centerplane inside the fluid domain and to adress it using "cfx5post"

Any idea how to use existing interfaces/tools?

Thanks in advance, Markus

Hi Markus,

check the previous posting titled "plotting results"

http://www.cfd-online.com/Forum/cfx.cgi?read=4476

I think this is what you are after.

Bob

Hi Bob,

that'S EXACTLY what I am after. Thanks a lot,

Markus