Import iges file into CFX5.4.1 in Unix system

May 2, 2003, 02:36

When I tried to import an iges file produce with Invetor6.0 in WindowXP system into CFX5.4.1 in Unix system, the following information was shown. "The specified file filename.igs is not a valid fixed(80 character) line length ASCII format" Can anyone help me? Bob, thank you for your information.

May 2, 2003, 08:28

What is the length of the path (should be less than 80 character)? Can the file be tared and read on Unix, or is the file corrupted after you transfered it?

PS: CFX-5 is now on 5.6 I believe (or about to be delivered); how come you are on 5.4.1?

May 5, 2003, 08:49

Use Hummingbird exceed3d software to transfer files from PC to UNIX platform. It will convert the files in proper format and will solve your problem.

May 2, 2003, 02:36	Import iges file into CFX5.4.1 in Unix system	#1
yli Guest Posts: n/a	When I tried to import an iges file produce with Invetor6.0 in WindowXP system into CFX5.4.1 in Unix system, the following information was shown. "The specified file filename.igs is not a valid fixed(80 character) line length ASCII format" Can anyone help me? Bob, thank you for your information.

May 2, 2003, 08:28	Re: Import iges file into CFX5.4.1 in Unix system	#2
Holidays Guest Posts: n/a	What is the length of the path (should be less than 80 character)? Can the file be tared and read on Unix, or is the file corrupted after you transfered it? PS: CFX-5 is now on 5.6 I believe (or about to be delivered); how come you are on 5.4.1?

May 5, 2003, 08:49	Re: Import iges file into CFX5.4.1 in Unix system	#3
tascflowuser Guest Posts: n/a	Use Hummingbird exceed3d software to transfer files from PC to UNIX platform. It will convert the files in proper format and will solve your problem.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] swak4foam building problem	GGerber	OpenFOAM Community Contributions	54	April 24, 2015 16:02
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
[Gmsh] Compiling gmshFoam with OpenFOAM-1.5	BlGene	OpenFOAM Meshing & Mesh Conversion	10	August 6, 2009 04:26
[OpenFOAM] Paraview command not found	hardy	ParaView	7	September 18, 2008 04:59
Compiling OpenFOAM13 on AMD64 with Redhat Enterprise	mbeaudoin	OpenFOAM Installation	20	June 17, 2008 06:43