GGI Error Message
Hello everyone,
I use CFX-Pre 5.6 to build a model in which five Patran Neutral blocks were imported. Domain Interfaces (no Frame change, no Pitch change) were assigned in the model. When I tried to solver the problem, I got the following error message in CFX 5.6 Solver. Anybody knows the reason and what should I do to revise the model? Thanks in advance! David ERROR #001100279 has occurred in subroutine ErrAction. | Message: | No control surfaces have been found at all for case and drill com- | . This is not supported. | ERROR #001100279 has occurred in subroutine ErrAction. Message: Stopped in routine SU_MESH_GGI |
Re: GGI Error Message
David,
One of your GGI interfaces is not overlapping. Carefully check that side 1 and side 2 are overlapping. You can do this in CFX-Pre or Post. Neale |
Thank you, Neale
Thank you Neale! You are right.
Regards David |
All times are GMT -4. The time now is 09:02. |